Description updated 12/28/2023: Freefly Alta 6 aerial drone with travel case, Futaba remote, Futaba charger, stand -- ready to fly
The Alta 6 was flown for 140.02 flight hours (see screenshots of log file). The Alta 6 drone body was updated and repaired by Freefly in 2020 (see RMA summary in photos). It was never flown or used since the refurbishment in 2020.
UPDATE: Please note Freefly's end-of-service announcement for the Alta 6:
https://freeflysystems.com/knowledge-base/alta-6-alta-8-alta-8-pro-end-of-service UPDATE: The Futaba remote and charger are in used condition, but they functioned very well throughout my time using this system, aside from a handful of unusual incidents, described below, that Freefly Support says they addressed in the 2020 RMA. I looked back at the email records and found a more detailed description of those incidents and Freefly Support's response to what may have caused them. The Futaba remote didn't have a case for travel, so it sustained more wear and tear than the drone did.
This is Freefly Support's description of the product checkup in 2020: Our product checkup addresses any structural damage or wear and tear to ensure the integrity of the aircraft. This may involve repairing or replacing damaged components. This does not mean everything on the airframe has been replaced. You could also argue that the unit came in for a production checkup and recertification more than a casual 'RMA' - and at the time the unit would have been sent back out with a warranty (which has now expired.)
The Alta 6 was tested by Freefly and shipped back to me in September 2020. I've kept it in safe, cool storage since then -- I thought I might end up using it again, but I never did. The entire Alta 6 drone body (including blades and all other attached components), stand, and travel case are in very good condition, almost "like new" aside from some very small scratches on the boom arms (photos included). I'm not sure what caused these. I took great pains to handle the Alta carefully the whole time I used it (I was the only user), but there was one incident where I messed up a takeoff and caused the Alta to immediately flip upside-down (barely making lift-off); it landed upside-down on a soft, grassy ground, from what I recall (it definitely wasn't pavement -- it was natural ground, I think part of an unpaved pathway/driveway), and while two of the blades were damaged (and then replaced), the Alta performed well on 59 separate dates after that (with multiple flights on each date), according to the folders in the SD card.
NOTE: The photos in the listing have been temporarily updated to show the scratches on the boom poles. In a few days I'm going to put the original photos back up, but after that, if you'd like to see the photos of the scratches, I can send them to you via WeTransfer or another file transfer service of your choice.
This is my description of the incidents with the radio control that had occurred prior to the 2020 RMA: I'm ready to ship my Freefly Alta 6 for a product checkup , but I have one question: is it permissible for me to ship my Futaba T14SG controller with the Alta, for the checkup team to inspect the communication between the Alta and the Futaba system? I've had about three or four episodes where I adjusted the "MODE" switch on my Futaba radio, but the Alta 6 didn't switch modes: e.g., I flipped the MODE switch to "GPS" mode, and the Alta 6 still remained in Manual or Altitude mode, which was alarming. In these cases, after flipping the MODE switch back to Manual and then back to GPS a couple times, the Alta 6 finally respo nds and properly switches to GPS mode, but the initial failed attempts are disconcerting. This has only happened a very few times, but the fact that it happened at all is alarming. I also had one episode where the Alta suddenly froze (hovering) in midair with all its lights flashing rapidly, and I was totally unable to control it with the radio for approximately 30 seconds. For no discernable reason, the Alta then stopped flashing and became responsive again, and I brought it in for a quick landing. After a few more test flights, the problem didn't recur, and I have no idea how I could reproduce the issue, but I thought I should alert Freefly in case they might be able to investigate possible causes. Other than that, there are no known issues with the Alta 6. It's been flying reliably since I purchased it.
This is Freefly Support's response to that issue:
WILL KING FROM FREEFLY:
Not a problem, I will submit your questions to the tech for answers. It will be difficult to try and troubleshoot your exact incident (especially if it happened once) and then apply that to a possible hardware failure. The tech will confirm there are no errors happening and take it for a test flight with your RC that you sent.
FREEFLY TECH'S INITIAL UPDATE:
His RC will be used for testing his final flight/burn-in. At this point I'm not sure if possibly his GPS is bad or what could cause his current issue. My plan is to replace all chassis bolts because they are rusty. Then test if everything works (synapse, GPS, his receivers, and RC).
FREEFLY TECH'S FINAL UPDATE:
ENG NOTES: I ended up replacing the distribution board with a new one instead of changing the EC5 connectors (this was the main issue). I looked back at their logs and never saw a radio loss fail. I had no problems connecting or flying the unit in all modes. I did replace the Futaba cables, the telemetry cable was broke at the end. All repair services include cleaning, full calibration, sequencing through our production validation test to verify function and quality. We also load the latest public firmware.
Please feel free to contact me if you have any questions. Thank you!